The SIFCO Process Model N Turning Head will provide years of trouble-free service as a light to medium duty rotating device. The turning head consists of a heavy-duty steel base, supporting a speed control and gear motor assembly with a drive bearing-mounted shaft, grounding bar and chuck. A power takeoff on the motor can be used to drive a Rotary Tool Handle or grinding accessory. Attaching the ROTO-FLO Flexible Shaft to the chuck allows to plate a vide range of ID surfaces. The right angle gearbox is coupled to a shaft supported by two sealed, heavy-duty, self-aligning pillow block type bearings. These bearings are equipped with convenient grease fittings to aid in the maintenance of the unit. A quality steel chuck is attached to a stainless steel back plate mounted on the shaft. This 3 jaw chuck comes complete with internal and external jaws, and a chuck wrench.
Request Information
Unit of Measure
Items
Turning Head Model N

Turning Head Model N
Turning Head Model N

Turning Head Model N
ROTO FLO Accessory

ROTO-FLO Assembly
Description N/A The SIFCO Process Model N Turning Head will provide years of trouble-free service as a light to medium duty rotating device. The turning head consists of a heavy-duty steel base, supporting a speed control and gear motor assembly with a drive bearing-mounted shaft, grounding bar and chuck. A power takeoff on the motor can be used to drive a Rotary Tool Handle or grinding accessory. Attaching the ROTO-FLO Flexible Shaft to the chuck allows to plate a vide range of ID surfaces. The right angle gearbox is coupled to a shaft supported by two sealed, heavy-duty, self-aligning pillow block type bearings. These bearings are equipped with convenient grease fittings to aid in the maintenance of the unit. A quality steel chuck is attached to a stainless steel back plate mounted on the shaft. This 3 jaw chuck comes complete with internal and external jaws, and a chuck wrench.
Drive Unit N/A 1/3 hp permanent magnet DC gearmotor with reversible, variable speed control box N/A 1/3 hp permanent magnet DC gearmotor with reversible, variable speed control box N/A
Chuck Capacity N/A 152 mm (6 in.) maximum diameter, with 610 mm (24 in.) maximum length. Internal and external jaws, for parts up to 23 kg (50 pounds) N/A 152 mm (6 in.) maximum diameter, with 610 mm (24 in.) maximum length. Internal and external jaws, for parts up to 23 kg (50 pounds) N/A
Rotating Speed N/A Adjustable from 0 to 500 rpm N/A Adjustable from 0 to 500 rpm N/A
Power Requirements N/A 115 VAC, 1Ø, 50/60 Hz, 6 amp N/A 230 VAC, 1Ø, 50/60 Hz, 3 amp N/A
Handle to Anode Thread Size N/A N/A N/A 1 in. -8 UNC male thread
For Bore Sizes N/A N/A N/A From approximately 38 to 127 mm (1.5 to 5 in.)
Flexible Cable N/A N/A N/A 91 cm (3 ft) long; 5 Nm (5 lb-in.) maximum dynamic torque at 64 cm (25 in.) radius of curvature.
Recommended Plating Amperage Range N/A N/A N/A Up to 75 amp